Arcom ZyWAN Manuel de service télécharger pdf (Page 20)

Installation and Setup

3-4 SM-1H1.0002, Rev. 1, July 2009

3.5. Verifying Installation

The TransPortal provides visual confirmation of connectivity and operation using a top panel

backlit LCD display and bi-color LED status indicators. See Figure 2-1.

3.5.1. Initialization

As the TransPortal powers up, the LCD top panel display typically shows the following;

TransPortal Remote

Monitoring Network

Ansalso-STS USA

Initializing…

As part of the power up sequence, the TIM checks operation of the four bi-color LED status

indicators on the top panel of the unit. Each LED state is tested (OFF, Red, and Green).

3.5.2. Operation

Following initialization, the LCD display shows the IP addresses of the Ethernet connection

between the TIM (typically ETH1) and the host server. A typical display is shown below.

Eth1 IP Address

192.168.1.110

SNMP Host Address

192.168.1.111

During operation, only the Communication Status and System Status LED indicators are used in

this application. Table 3-1 describes the TIM status for each state of the active LED indicators

in this application.

Table 3-1. Active Top Panel LED Indicators

ACTIVE LED DESCRIPTION

Communication Status LED

Green

Connected to and communicating with

the MICROLOCK II controller

Red

ICROLOK II controller communication

link pre-empted or lost

Off Communication software not running

System Status LED

Green System software running

Red System software not running



1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Pas de commentaire

Arcom ZyWAN Manuel de service Page 20