Arcom ZyWAN Manuel d'utilisateur télécharger pdf (Page 59)

ZyWAN User Manual Configuring the ZyWAN

Terminal Clients

The Terminal Clients tab looks like this:

The various items must be configured in order to set up Terminal Client services. The

Terminal Client makes an outbound TCP/IP connection to a remote server, allowing

pass-through communication with a local serial port. Its serial port also provides AT

command emulation, to act similar to a dial modem.

After setting all the Terminal Client properties, click the Submit New Configuration

button before switching to a new tab or closing the window.

Changes made to the Terminal Client page take effect immediately after

submitting changes, without requiring a reboot.

To allow one or more Terminal Client services to be configured, set Enable Terminal

Clients to Yes. The Table of Terminal Clients is displayed:

The following buttons are available:

Button Explanation

Insert Row#

Each of the Terminal Clients exists as a large set of properties in a

numbered table row. In order to insert a row in the table, enter a

number in the box between 1 and one greater than the highest

number of rows. Then click the Insert Row# button to insert a blank

row. This row must be filled in with all data required.

Note that this table can get very large, with inner tables on each

Terminal Client table row. When adding or deleting a Terminal Client

configuration, make sure to click the Insert Row# or Delete Row#

buttons at the very bottom of the main table.

Delete Row#

In order to delete a Terminal Client configuration (a row in the main

table), enter a number in the box between 1 and the highest number

of rows. Then click the Delete Row# button to delete the row. Once

a row is deleted, it cannot be restored without inserting a row and

entering the data again.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 75 76

Pas de commentaire

Arcom ZyWAN Manuel d'utilisateur Page 59